General Guidelines; Mounting The Device - HQ Power VDPL1801MHW10 Bedienungsanleitung

3. General Guidelines

• This device is designed for professional use on stage, in discos, theatres, etc. The VDPL1801MHW10 should
only be used indoors with an alternating current of max. 230VAC / 50Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture. Respect a minimum distance of 0.5m between the device's light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.

4. Mounting the Device

• Have the device installed by a qualified person,
respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10
times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a
secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being
mounted, removed or serviced. Have a qualified
technician check the device once a year and once
before you bring it into service.
• Install the device in a location with few passers-by
that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience:
calculating workload limits, determining the
installation material to be used... Have the material
and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Description
1. DMX in
2. DMX out
3. power selector
4. power switch
5. microphone
6. LCD
7. ENTER
VDPL1801MHW10
8. DOWN
9. UP
10. MODE
11. power input
4 HQPOWER