ASROCK H55M-LE Handbuch Seite 16

Downloaded from www.Manualslib.com
2.5 Jumpers Setup 2.5 Jumpers Setup 2.5 Jumpers Setup 2.5 Jumpers Setup 2.5 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.2, No. 2)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
USB_PWR1 (PORT 6-9)
(see p.2, No. 19)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2 No. 16)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power supply.
After waiting for 15 seconds, use a jumper cap to short pin2 and pin3 on CLRCMOS1
for 5 seconds. However, please do not clear the CMOS right after you update the
BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you
must boot up the system first, and then shut it down before you do the clear-
CMOS action.
If you clear the CMOS, the case open may be detected. Please adjust
the BIOS option "Clear Status" to clear the record of previous chassis
intrusion status.
16 16
16 16 16
manuals search engine
Short
Setting
Short pin2, pin3 to enable
+5VSB (standby) for PS/2
or I/O panel USB wake up
events.
Short pin2, pin3 to enable
+5VSB (standby) for
USB6_7 and USB8_9 wake
up events.
Default Clear CMOS
ASRock H55M-LE Motherboard
Open
Description