Axis 221 Installationsanleitung Seite 4

Page 4
Overview
Rear panel
AC AC
GND DC+
Connections
1. Connect the AXIS 221 to your network using a standard network cable.
2. Connect power, using one of the 3 supported methods listed below:
• The supplied power adapter.
• PoE (Power over Ethernet) via the network cable. This will automatically be detected if
available via the network.
• The power connector block on the rear panel. See the illustration above.
Downloaded from www.Manualslib.com
Serial number
on underside
label
DC-Iris control cable
10-pin I/O terminal
connector
Power
connector
block
Power adapter
connector
Connect AC power (10-24V) on pins 2 and 3.
Connect DC power (7-24V) on pins 1 and 2.
manuals search engine
Status
indicator
Reset
Power indicator
button
Network indicator
RS-232
connector
AXIS 221 Installation Guide
Zoom puller
(Tele/wide)
Focus puller
DC-Iris
Network
connector
(also PoE)
DC-Iris control cable