Navigate Mode Functions; To Operate Navigate Mode; To Store Waypoints In Navigate Mode; To View Performance Data In Navigate Mode - Timex Bodylink System Handbuch

Navigate Mode functions

Navigate Mode displays directional information and tracks your
speed, distance, and altitude during an activity. While you can set
up to 10 waypoints to mark specific locations during your activity,
this mode does not operate like a compass. You must be moving for
accurate heading information.
In addition, Navigate Mode does not operate in conjunction with
the chronograph. This mode displays and automatically updates
current positional information, but does not keep time.
NOTE: Navigate Mode will not operate without the use of the
GPS-3D Sensor. If the GPS-3D Sensor is not operational,
you will receive the message: NO GPS DATA.

TO OPERATE NAVIGATE MODE

1. Press MODE until Navigate Mode appears.
2. Begin moving. The Watch automatically updates the
information displayed on the Watch.
If you stop moving the altitude and heading values freeze.

TO STORE WAYPOINTS IN NAVIGATE MODE

For Navigate Mode, you can only store waypoints. For all other
waypoints options, you must use Waypoints Mode.
For instructions on storing waypoints, refer to "To store a
waypoint" on page 42.
38
Downloaded from www.Manualslib.com manuals search engine

TO VIEW PERFORMANCE DATA IN NAVIGATE MODE

When using Fitness Sensors with your Watch, scroll through
performance data by pressing and releasing DISPLAY.
All data in Navigate Mode requires the GPS-3D Sensor.
Performance data viewing options for Navigate Mode include:
Longitude: East/West position expressed in degrees, minutes,
and seconds from the Greenwich Meridian.
Latitude: North/South position expressed in degrees, minutes,
and seconds from the equator.
Heading: The direction you are traveling.
Speed: Current velocity.
Distance: Distance traveled since the activation of the GPS-3D
Sensor.
Altitude: Current height above sea level.
39