Finish Mode; Finish Mode Functions; To Set Finish Mode; To View Performance Data In Finish Mode - Timex Bodylink System Handbuch

Finish Mode

INDIGLO®
night-light
To Navigate Mode
or hold for time
Start timing or
take a split.

Finish Mode functions

Finish Mode allows you to predict how much time it will take you
to finish a specified distance based on current GPS-3D Sensor
data. To help you stay on pace for your predicted finish, you can
also set the Watch to alert you if you are moving either too quickly
or too slowly for your desired pace.
NOTE: If you do not use the GPS-3D Sensor, Finish Mode
operates identically to Chronograph Mode, displaying only
time and lap information.
You must reset the chronograph to zero prior to operating
Finish Mode or it will not operate properly.
34
Downloaded from www.Manualslib.com
View performance
data
Stop timing
manuals search engine

TO SET FINISH MODE

For instructions on setting Watch functions, including Finish
Mode, refer to page 13, "To set Watch functions."
For Finish Mode, you can set the following values:
Pre-set or custom distance [(for custom set the distance (up to
999.99) and the unit (NM, KM, or MI)]
Target time
Alert option (an audible alert will cause the Watch to both beep
and flash the predicted finish time and a silent alert will only
flash the predicted finish time)

TO VIEW PERFORMANCE DATA IN FINISH MODE

When using Fitness Sensors with your Watch, scroll through
performance data by pressing and releasing DISPLAY.
Performance data viewing options for Finish Mode include:
Finish Time: The predicted finish time based on your current
speed and distance. The finish time will flash if you move
slower or quicker than your predicted finish time. If you stop
moving, the Watch replaces the finish time with STOPPED.
(requires GPS-3D Sensor)
Pace: Current velocity, expressed in minutes per selected
distance unit, such as miles or kilometers (requires GPS-3D
Sensor).
35