NEC MultiSync Flat Professional Serie Bedienungsanleitung Seite 6

Quick Start
4. Connect one end of the power cord to the MultiSync
5. Turn on the monitor (Figure E.1) and the computer.
6. The Factory Setting for your monitor is set for D-SUB installation. If you are using a
NOTE: For download information on the Windows
NOTE: If you have any problems, please refer to the Troubleshooting section of
78134171
Downloaded from www.Manualslib.com
end to the power outlet (Figure D.1).
BNC cable connection, push the BNC/D-SUB button on the front of the monitor
(Figure E.1) to switch settings.
Figure A.2
R G(/Sync) B
HS/CS
Figure C.1
Series monitor, refer to the References section of this user's manual.
this User's Manual.
EXIT
manuals search engine
cont.Start
®
VS
Power Outlet
BNC
Connector
® 95/98 INF file for your MultiSync FP
BNC/D-SUB
MultiSync
PROCEED RESET BNC/D-SUB
Figure E.1
4
6
FP Series monitor and the other
Figure B.2
Power
Cord
Figure D.1
Power Button
12/3/98, 4:10 PM