Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The CHARGE LED shows a red light when the M266 is charging. The LED shows a green light once the
M266 is charged. In order to ensure a correct display, the M266 must be switched off. If the M266 is
switched on, the CHARGE LED may show a red light although the battery is already charged.
14 Cleaning and maintenance information
Clean the device by placing it firmly onto a surface (e.g. table). This ensures a secure hold and the device
cannot slip out of your hand during the cleaning process.
14.1 Display/membrane keyboard
In order to clean the display or membrane keyboard, always switch off the device as the display responds to
all contact and could therefore compromise or interfere with the active program. Do not apply any severe
pressure to the display.
14.2 Charging contacts
If charging issues occur, clean the charging contacts with a soft, moist cloth.
When dealing with the DS266, the power plug must be disconnected beforehand!
14.3 Scanner glass
In the event of any irregularities during scanning, switch off the device and clean the scanner glass with
a soft, dry cloth. The scanner glass is ultra-transparent and can hardly be seen with the naked eye. Shape
the cloth in such a manner that it can easily be moved back and forth in the scanner shaft. Do not apply
excessive pressure to the glass.
ATTENTION
15 Miscellaneous:
EU directive on the disposal of waste electrical and electronic
equipment (WEEE, Waste Electrical and Electronic Equipment)
All components must be returned to ACD for recycling
at the end of their service lives.
WEEE: 53473276
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU member
states and EFTA countries, except in France and Italy where restrictive use applies.
NOTE
NOTE
M266_Set_Kurzübersicht_V1 01_de_en.doc
Do not use any corrosive chemicals, cleaning solutions or strong
cleaning agents in order to clean the device.
In Italy the end-user should apply for a license at the national spectrum
authorities in order to obtain authorization to use the device for setting
up outdoor radio links and/or for supplying public access to
MICommunications and/or network services.
This device may not be used for setting up outdoor radio links in France
and in some areas the RF output power may be limited to 10 mW EIRP
in the frequency range of 2454 – 2483.5 MHz. For detailed information
the end-user should contact the national spectrum authority in France.
11 / 12
Werbung
Inhaltsverzeichnis
