Using The Built-In Timer; Setting The Clock; Adjusting The Brightness Of The Display - Yamaha CRX-E150 Bedienungsanleitung

USING THE BUILT-IN TIMER

Setting the clock

You must set the clock before you use the timer functions.
The clock is based on a 24-hour system.
DISPLAY
NATURAL SOUND CD RECEIVER CRX-E150
STANDBY/ON
TIMER
STANDBY
DISPLAY MEMORY AUTO/MAN'L PRESET/BAND
TIME ADJ
PHONES
TIME ADJ
1
While the power is on, press DISPLAY to display
the time.
2
While holding TIME ADJ, press HOUR to set the
hour.
• If you want to move the time in the reverse
direction, press HOUR while holding TIME ADJ
and PRESET/BAND.
3
While holding TIME ADJ, press MIN to set the
minutes.
• If you want to move the time in the reverse
direction, press MIN while holding TIME ADJ
and PRESET/BAND.
To display the clock
Press DISPLAY.
The current time appears for about 8 seconds, then the
normal display returns. Some buttons and controls may
not work while the current time is displayed.
Note
• In the event of a power failure or when the AC power cord is
disconnected for more than five minutes, you must reset the
clock.
18
HOUR MIN
VOLUME
MIN
PRESET/TUNING
TIMER HOUR MIN
INPUT
BASS TREBLE BALANCE
– + – +
L R
PRESET/BAND
Adjusting the brightness
You can adjust the brightness of the display. If you have
connected cassette deck (KX-E100) and/or MD recorder
(MDX-E100) to this unit, the brightness of the displays is
automatically adjusted to that of this unit.
NATURAL SOUND CD RECEIVER CRX-E150
MAX
STANDBY/ON
PHONES
Press and hold DISPLAY for about two seconds so that
"Dimmer ±0" appears on the display. While holding
DISPLAY, turn INPUT clockwise to increase or
counterclockwise to decrease brightness.
Control Range: ±0 to –6 (Preset value: ±0)
of the display
DISPLAY
TIMER
STANDBY
MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING
DISPLAY
TIME ADJ TIMER HOUR
BASS TREBLE
– + – +
VOLUME
MIN MAX
MIN
INPUT
BALANCE
L R
INPUT