Connecting Other Components - Yamaha CRX-E150 Bedienungsanleitung

To enhance your system, you can connect other component. Refer to the instructions of each component.
Connecting KX-E100 and MDX-E100
<MDX-E100>
System
control cable
(supplied with
ANALOG
IN D C OUT
L
KX-E100)
R
<KX-E100>
IN B
L
R
1
Connect Å to Å, and ı to ı (for connecting KX-E100), Ç to Ç and Î to Î (for connecting MDX-E100) using
RCA pin cable.
2
Connect DIGITAL OPTICAL OUT of CRX-E150 to DIGITAL OPTICAL IN of MDX-E100.
Take off the covers of the optical fiber cable plug, the DIGITAL OPTICAL OUT jack, and the DIGITAL OPTICAL
IN jack before making digital connections. Be sure to replace the terminal's cover when the terminal on the rear panel
is not being used, in order to protect from dust.
3
Connect an external component to the AUX terminal of CRX-E150.
4
Connect CRX-E150 and KX-E100 or MDX-E100 with the system control cable.
The connection using the SYSTEM CONNECTOR jack allows you to control this unit as well as the connected
components of YAMAHA PianoCraft series.
• If your system does not include MDX-E100, connect CRX-E150 and KX-E100 directly.
5
AC OUTLET
Connect the AC power plug of MDX-E100 to the AC outlet of CRX-E150. Then connect the plug of KX-E100 to the
AC outlet of MDX-E100.
• If your system does not include MDX-E100, connect the plug of KX-E100 to the AC outlet of CRX-E150.
Caution
• Never turn CRX-E150 on until all connections between components have been completed.
• Never connect or disconnect the system control cable and/or power cord while the system components are turned on.

Connecting other components

Optical fiber cable (EIA standard)
(commercially available)
SYSTEM DIGITAL
System control cable
CONNECTOR OPTICAL
1 2
(supplied with MDX-
IN
E100)
RCA pin cables
A OUT
SYSTEM
CONNECTOR
GETTING STARTED
As this terminal is used for an
examination in the factory, do not
connect any equipment to this terminal.
2
FM ANT GND – AM ANT SPEAKERS
75Ω UNBAL.
R L
DIGITAL
SUBWOOFER
OPTICAL
OUT OUT
SYSTEM CONNECTOR
6Ω MIN. /SPEAKER
C
CLASS 2 WIRING
IN 4
MD
OUT
D
A
1
IN
TAPE
OUT
B
AUX
3
IN
R L
5
To wall
outlet
<CRX-E150>
7