G) Changing/Selecting The Measuring Unit; H) Recalling Stored Readings - VOLTCRAFT SLX-300 Bedienungsanleitung

For more information, see section b) "Enabling/disabling the automatic power off function". The duration of the au-
tomatic measurement cycle can be preset. This duration can be configured in time mode. For more information, see
section i) "Time mode (TIME)".

g) Changing/selecting the measuring unit

5-4 UNIT Mode
S
Press the S button to toggle unit. (1W/m

h) Recalling stored readings

5-5 MEM Mode
DATA00 DATA01~DATA20
Up / Down
Press the Up (S) and Down (M) button to recall the stored data.
The saved data sets are marked with "REC" or "AUTO REC". "REC" means that the data set was manually saved.
See "Saving readings (REC)" for details.
"AUTO REC" means that the data set was automatically saved. See "Automatically measuring and recording readings
(AUTO REC)" for details.
Displaying the duration of the automatic measurement cycle
1
DATA00
Deleting saved data
2
DATA00
24
• Press and hold the M/DOWN button (2) for 2 seconds to start the automatic
measurement cycle. The AUTO (I) and REC (J) symbols will appear on the
LCD display. The meter will then start to take measurements.
• Hold down the M/DOWN button (2) for 2 seconds to end the automatic meas-
urement cycle. The AUTO (I) and REC (J) symbols will disappear from the
LCD display.
• Press the S/UP button (3) to change the measuring unit.
• Press the S/UP button to switch between the W/m
2 2
= 0.3169984BTU/ft
•h)
• Press the S/UP (3) or M/Down (2) button to recall the saved data
DATA
• Press the S/UP (3) or M/DOWN (2) button until the "DATA00" memory slot is
displayed. The preset duration of the previous automatic measurement cycle
will be displayed.
• You now know the duration of the previous measurement cycle. See section
"i) Time mode (TIME)" for details.
• Press the S/UP (3) or M/DOWN button (2) repeatedly until the "DATA"
memory slot is displayed. "Clr ALL" will be displayed.
• Press the
DATA
units. The selected unit will be displayed (1 W/m
BTU/ft xh).
2
sets in a cycle (there are up to 20 data sets in separate memory
slots).
/HOLD button (4) twice to delete all saved data.
and BTU (ft *h)
2 2
= 0.3169984
2