Refilling With Water - Dupray Stream Cleaner Bedienungsanleitung

CONNECTING THE STEAM HOSE
Connect the steam hose by inserting the steam hose connector in the steam hose connection outlet and
press firmly. Make sure it cannot be pushed in any further and that the locking pin on the flap is in place.
IMPORTANT:
Make sure the locking pin on the flap is inserted in the hose connection.
ADJUSTING THE STEAM PRESSURE
Adjust the desired steam pressure using the steam pressure regulator wheel located on the hose handle,
from minimum (-) to maximum (+). Connect the accessory that you want to use to the steam hose.
To release steam, simply press the steam release trigger on the hose handle.

REFILLING WITH WATER

If the low water indicator comes on during usage and you would like to continue using the steam cleaner, you will need to follow these steps:
When the water level inside the tank is low, the machine will hum every
few seconds, then the red low water indicator will turn on and the low
water alarm will sound.
Refill the water tank with up to 2.44L (or 0.64 gal) of water and keep
steaming. Equipped with CST™, your steam cleaner can be refilled with
water at any time during operation.
TURNING THE MACHINE OFF
When you are done using your steam cleaner, turn the main dial to the OFF position
and unplug the unit.
STORING YOUR STEAM CLEANER
It is safe to leave water in the boiler when the steam cleaner is not in use.
If it is for an extended period of time (months), then it is best to flush out the remaining water.
To do so, follow the water removal instructions as outlined in the maintenance of the boiler
section on page 17.
CAUTION :
This machine shall be stored indoors only.
en
TRAINING VIDEOS
AT DUPRAY.COM
10