Troubleshooting - Dupray Stream Cleaner Bedienungsanleitung

TROUBLESHOOTING

Do not operate the steam cleaner with a damaged cord, plug or if the steam cleaner has been dropped or damaged. To avoid risk of electric
shock, do not disassemble or attempt to repair the unit on your own. Return the unit to Dupray for examination, repair or replacement.
All service is to be performed by authorized professionals of Dupray service centers.
PROBLEM POSSIBLE CAUSE
No steam is released through the hose and
A. Steam cleaner is not turned on.
accessories.
B. Water reservoir is empty
C. Unit is not plugged in.
D. Boiler is not fully heated.
E. The hose is not properly connected.
Drops of water leak from the attachments. A. Unit is not fully heated.
B. Condensation was created from non-use.
C. O-rings need to be replaced.
Dirty water is coming out. A. Scale may have built up.
Not enough steam pressure. A. The dial on the handle may be set
too low.
B. Scale may have built up.
Pump is not stopping (humming noise). A. An air bubble may be in the pump.
B. Water tank is empty.
REMEDY
A. Follow the instructions on page 08.
B. Add 2.44L (0.64 gal) of water to the reservoir.
C. Plug unit into outlet.
D. Wait for the SteamReady™ indicator (7)
to turn on.
E. Make sure you push the hose all the way in
the connection outlet (3) and insert
the locking pin in place.
A. Wait for the SteamReady™ indicator (7)
to turn on.
B. Let water run through system until steam
comes out.
C. Replace O-rings.
A. Follow maintenance instructions
on page 17.
A. Turn the steam pressure regulator wheel until
the desired pressure is reached.
B. Follow maintenance instructions
on page 17.
A. Press the steam release trigger on the
steam handle. Hold for a few seconds untill
the pump is primed.
B. Put required amount of water into tank.
PROBLEM POSSIBLE CAUSE
Pressure is dropping during operation. A. Pressure set to max for too long.
Machine is not heating. A. Out of water (light may not be on).
B. Steam cleaner is OFF.
The electrical cord is damaged. A. Replace power cord.
The hose keeps falling out of the A. The hose is not properly connected.
connection outlet.
The white lever on the rectangular or A. The arrow on the connector and the dot
triangular tool cannot change position. on the tool are not lined up.
en
REMEDY
A. Use lower pressure setting.
A. Follow the instructions on page 08.
B. Turn to setting.
A. Contact Dupray at + 44 333 011 2660 for
replacement.
A. Make sure you push the hose in all the
way and ensure the locking pin is in
place.
A. Rotate the connector so that the arrow
on the connector and the dot on the
tool line up. Slide the white lever to
the correct position.
20