Specifications - Murray 285Z serie Bedienungsanleitung

Specifications

ENGINE
Briggs & Stratton
Intek Series
Model
Displacement 40.03 cu in. (656 cc)
Electrical System Alternator: 9 amp Regulated,
Battery: 12V-195 CCA
Oil Capacity 64 oz (1,9 L)
Engine Oil Synthetic 5W30
Spark Plug Gap 0.030 in. (0,76 mm)
180 in-lbs (20 Nm)
Spark Plug Torque
CHASSIS
Fuel Tank Capacity: 3.0 Gallons (11,4 L)
Front Wheels Tire Size: 11 x 4.0
Inflation Pressure: 12-14 psi (0,82 -0,96 bar)
Rear Wheels Tire Size: 18 x 8.5
Inflation Pressure: 10 psi (0,68 bar)
Power Rating
The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive Engineers)
code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995. Torque values are derived
at 2600 RPM for those engines with "rpm" called out on the label and 3060 RPM for all others; horsepower values are derived at 3600
RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power values are taken with exhaust and
air cleaner installed whereas gross power values are collected without these attachments. Actual gross engine power will be higher
than net engine power and is affected by, among other things, ambient operating conditions and engine-to-engine variability. Given the
wide array of products on which engines are placed, the gasoline engine may not develop the rated gross power when used in a given
piece of power equipment. This difference is due to a variety of factors including, but not limited to, the variety of engine components
(air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature,
humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an
engine of higher rated power for this engine.
Parts and Accessories
See an authorized dealer.
28
, 7200 Series
TM
TRANSMISSION
Make
Model
Type
Hydraulic Fluid
MOWER DECK
Cutting Width
Base Deck Platform
Number of Blades/Type
Frame Suspension
Deck Support Wheels/Number Standard, 2 Front / 2 Rear
Height-of-Cut
Mower Lift
Cutting Positions
Hydro Gear
ZC-AUBB-2ADB-1DPX (LH)
ZC-DUBB-2ADB-1DPX (RH)
EZT
Sealed Unit
42" (106,7 cm)
Side Discharge
3, Standard Lift
Frame Hung
Anti-Scalp Wheels
1.75" to 4.0" (4,4 to 10,0 cm)
Electric Height-of-Cut
Infinite