Fuel Filter; Engine Maintenance - Murray 285Z serie Bedienungsanleitung

Checking / Adding Fuel
To add fuel:
1. Remove the fuel cap.
2. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.

Fuel Filter

The fuel filter is located in the fuel line between fuel tank
and fuel pump. If the filter is dirty or clogged, replace as
follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled fuel.
3. Using pliers, open and slide hose clamps from fuel
filter (A, Figure 10).
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when finished.

Engine Maintenance

Refer to engine manual for all engine maintenance
procedures and recommendations.
en
WARNING
Gasoline is highly flammable and must be handled with
care. Never fill the tank when the engine is still hot from
recent operation. Do not allow open flame, smoking or
matches in the area. Avoid over-filling and wipe up any
spills.
Do not remove fuel filter when engine is hot, as spilled
gasoline may ignite. DO NOT spread hose clamps
further than necessary. Ensure clamps grip hoses firmly
over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damage
could result.
Figure 10. Fuel Filter Replacement
(View looking back from battery compartment)
A
21