Junker JM16AA50 Gebrauchsanleitung Seite 132

Problem
Three zeros flash in the display.
The appliance is not in operation. A
cooking time appears in the display. g pp
The microwave does not work.
The food takes longer than usual to
heat up.
The turntable is making a scratching
or grinding noise.
Microwave operation is cancelled for
no obvious reason.
132
Possible cause
Power cut
Blown fuse
Faulty control
Power cut
The rotary knob was
accidentally pressed.
p y
Start was not pressed after
the setting had been made.
The door is not properly
closed.
Start was not pressed.
The microwave setting is
too low.
You have placed a larger
amount of food than normal
in the appliance.
The food was colder than
usual.
There is dirt or a foreign
object in the area around
the turntable drive.
The microwave has a fault.
Repairs may only be carried out by fully trained
after sales service technicians. Incorrect repairs
may result in serious injury to the user.
Notes/remedial action
Check whether the kitchen light
switches on.
Look in the fuse box to make sure
that the fuse for the appliance is
OK.
Switch the appliance off using the
fuse in the fuse box. Wait
approximately 10 seconds and
then switch it back on.
Reset the time.
Press the Stop button.
Press Start or clear the setting
with Stop.
Check whether leftover food or a
foreign object is trapped in the
door.
Press Start.
Select a higher microwave
setting.
Double the amount = double the
cooking time.
Stir or turn the food during
cooking.
Clean the roller ring and recess in
the cooking compartment.
If this fault occurs repeatedly,
please call the after sales service.