Ip Ospf Area - Hirschmann MSP40 Referenzhandbuch

Open Shortest Path First (OSPF)
40.1 ip
40.1 ip
Set IP parameters.
40.1.1

ip ospf area

Configure the OSPF router area. A router area is a sub-division of an OSPF autonomous system and
you identify an area by an area-id. OSPF networks, routers, and links that have the same area-id form
a logical set.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf area <P-1> range add <P-2> <P-3> <P-4> modify <P-5> <P-6>
<P-7> <P-8> delete <P-9> <P-10> <P-11> add delete stub add <P-12> modify
<P-13> summarylsa <P-14> default-cost <P-15> delete <P-16> virtual-link add
<P-17> delete <P-18> modify <P-19> authentication type <P-20> key <P-21>
key-id <P-22> hello-interval <P-23> dead-interval <P-24> transmit-delay
<P-25> retransmit-interval <P-26> nssa add <P-27> delete <P-28> modify
translator role <P-29> stability-interval <P-30> summary no-redistribute
default-info originate [metric <P-31>] [metric-type <P-32>]
range: Configure the range for the area. You summarize the networks within this range into a single
routing domain.
add: Create a router area.
modify: Modify the parameters of a router area.
delete: Delete a specific router area.
add: Create a new area.
delete: Delete a existing area.
stub: Configure the preferences for a stub area. You shield stub areas from external route
advertisements, but the area receives advertisements from networks that belong to other areas of the
same autonomous system.
add: Create a stub area. The command also allows you to convert an existing area to a stub area.
modify: Modify the stub area parameters.
summarylsa: Configure the summary LSA mode for a stub area. When enabled, the router both
summarizes and propagates summary LSAs.
default-cost: Set the default cost for the stub area.
delete: Remove a stub area. After removal, the area receives external route advertisements.
virtual-link: Configure a virtual link. You use the virtual link to connect the router to the backbone
area (0.0.0.0) through a non-backbone area or to connect two parts of a partitioned backbone area
(0.0.0.0) through a non-backbone area.
add: Add a virtual neighbor.
delete: Delete a virtual neighbor.
modify: Modify the parameters of a virtual neighbor.
authentication: Configure the authentication type. The device authenticates the OSPF protocol
exchanges in the OSPF packet header which includes an authentication type field.
type: Configure the authentication type. Authentication types are 0 for null authentication, 1 for simple
password authentication, and 2 for cryptographic authentication.
key: Configure the authentication key.
386 RM CLI HiOS-2A MSP40
Release 6.1 09/2016