Address-Conflict; Address-Conflict Operation; Address-Conflict Detection-Mode - Hirschmann Msp40 Referenzhandbuch

Address Conflict Detection (ACD)

2.1 address-conflict

2.1 address-conflict
Configure the address conflict settings.
2.1.1

address-conflict operation

Enable or disable the address conflict component.

Mode: Global Config Mode

Privilege Level: Operator

Format: address-conflict operation

no address-conflict operation
Disable the option

Mode: Global Config Mode

Privilege Level: Operator

Format: no address-conflict operation
2.1.2

address-conflict detection-mode

Configure the detection mode.

Mode: Global Config Mode

Privilege Level: Operator

Format: address-conflict detection-mode <P-1>
Paramete Value
r
active-and-passive
P-1
active-only
passive-only
40
Meaning
Configure active and passive detection. During the ip address
configuration, if you set the detection to 'active', then the
device sends ARP or NDP probes into the network, and if you set
the detection to 'passive', then the device listens continuously
on the network.
Configure only active detection. During ip address configuration
'active' the device sends only one ARP or NDP probe into the
network.
Configure passive detection. The device listens passively on the
network to verify that another device does not have the same ip
address assigned.
RM CLI HiOS-2A MSP40
Release 6.1 09/2016