Inhaltsverzeichnis
Werbung
wasco
®
Please consult your network administrator which IP address you may use.
If you use an invalid IP address the access to the module may then be
impossible. The setting of the most important impermissible addresses is
blocked by the module.
4.9 Configuration with Dynamic IP Address (DHCP enabled)
If you want to implement the EXDUL-581 into an existing network with
an already active DHCP server and to map it via a dynamic IP address,
DHCP (Dynamic Host Configuration Protocol) has to be activated in the
configuration screen of the web page. In factory default setting, DHCP is
already activated and there is no need to change.
If the IP address is set statically, activate DHCP as follows:
Connect the EXDUL-581 to a computer using a network cable (older compu-
ters may need a crossover network cable). Please make sure that the com-
puter is set to: Folgende IP-Adresse verwenden: (DHCP deaktiviert)
The network part of the IP address (see chapter 4.6 Composition and
structure of IP address) has to be transferred from the IP address of the
EXDUL-581, because the computer and the EXDUL are to be located in
the same network.
Connect the power supply (+10 V ...+30V) across terminals 23 (Vcc) and
24 (GND) of the module. The EXDUL will boot up immediately. Once a
stable connection is established, the LED on the left side of the RJ45 jack
is lit green continuously.
Access to the EXDUl-581 web page is possible using any internet browser
entering the hostname or IP address of the EXDUL-581. The browser now
should open the EXDUL web page. Clicking the TCP/IP Config button
opens the configuration screen and you can acitivate DHCP by setting the
checkmark Enable DHCP as shown in the following figure:
EXDUL-581E / EXDUL-581S © 2019 by Messcomp Datentechnik GmbH
EV03
16
Werbung
Inhaltsverzeichnis
