How To Change The Network Configuration - Wasco EXDUL-581E Bedienungsanleitung

wasco
®

4.7 How to Change the Network Configuration

To change the factory default configuration settings, connect the EXDUL-581
to a local network using the enclosed standard network cable and connect
the power supply (+10 V ...+30 V) across terminal 23 (Vcc) and terminal
24 (GND) of the module.The EXDUL boots up immediately. Once a stable
Ethernet connection is established, the green LED on the left side of the
RJ45 jack is lit green continuously. Access to the EXDUl-581 web page
is possible using any web or internet browser by prompting the hostname
http://EXDUL-581. Click the TCP/IP Config button to open the following
configuration screen:
You can use the enclosed standard network cable to connect EXDUL-581
also directly to a host PC with an Ethernet interface. If you connect directly,
normally no DHCP service is available, for neither the PC nor the EXDUL
provides one. In this case, the last set static IP address can be used for
addressing the EXDUL-581. The IP address 169.254.1.1 is applicable for
factory-new EXDUL devices.
EXDUL-581E / EXDUL-581S © 2019 by Messcomp Datentechnik GmbH EV03
13