Acoms TECHNISPORT 2.4G II Bedienungsanleitung Seite 8

Do not install the receiver in a low position of a large scale model. The antenna wire must
protrude sufficiently to receive a clear signal. Furthermore, if the receiver is surrounded by
metal components (i.e. a roll cage) the signal may be subject to interference. In these
instances the receiver should be repositioned at the front or on the upper sections of the model.
To avoid direct vibration during driving, receiver should be fixed in a place which will not touch other
parts using thick double sided tape. When installing in a car with an engine, the receiver should
be protected with sponge to prevent shock or vibration which could result in malfunction.
The receiver and antenna should not be close to motor, speed controller, battery or
silicon cord, as this can cause interference due to electrical noise.
Operate each servo and check that no unnecessary throw is exerted on the push rod,
which can cause servo damage or shorten battery life.
Servo should be fixed with rubber grommets in a place which will not touch with other parts
to avoid direct vibration to the servo, otherwise servo may be damaged by shock or vibration.
When used in an engined car, be careful that fuel or exhaust gases do not come into
contact with the receiver.
Caution receiver antenna installation
Never cut, lengthen or bind the antenna wire as the
wavelength for 2.4GHz is short and it is very sensitive to
the length of antenna wire.
Keep the antenna wire away from metal or carbon material.
In case the antenna is installed outside, it should be
as close to the receiver as possible. If the antenna wire
from receiver to holder is longer, the sensitivity is reduced.
Do not attach the antenna wire directly to metal or carbon.
Do not site the antenna wire near electric conductors such
as metal or carbon which will reduce sensitivity due to
interference.
As depicted in the illustration on the right, antenna wire should
be installed more than 30mm away from the electric
conductor.
Also note that the middle part of the antenna wire should
not be close to metal or carbon.
Caution when installing the receiver
Receiver
PCB
7
Antenna top