Acoms TECHNISPORT 2.4G II Bedienungsanleitung Seite 7

Connecter must be fitted firmly. If
the connecter is not fixed
correctly, it may become
disconnected and cause vehicle
to go out of control.
When the connecter is
removed, pull it by the housing
not by the cable.
Set up button
Connect the battery and motor with correct polarity.(* Incorrect polarity causes product damage)
The manufacturer and distributor will accept no responsibility, expressed or implied, for problems
caused by usage of Non-genuine parts.
When you have finished driving your car, remove batteries to prevent danger of
activation if accidentally switched on.
The plug must only be fitted facing one
direction. Always ensure that the black cable
lead wire is facing outwards when the servo
and switch harness are connected to
the receiver.
6