Safety Guidelines - Acoms TECHNISPORT 2.4G II Bedienungsanleitung

SAFETY GUIDELINES

It is important that you read and understand the instructions completely before use.
Misuse of this product could cause fire or injury.
Please keep this manual for future reference in order to prevent accidents.
This product is not recommended for use by children less than 14 years of age without
adult supervision.
In the event of
Smoke
Burning smell
Strange sound
Water or any liquid
coming into contact
with the product
Or if it is dropped
or damaged.
Please read before use
This product is designed only for radio control ground models. Not recommended for use in
boats or flying models.
The manufacturer and distributor will accept no responsibility, expressed or implied, for
injuries caused as a result of dismantling or modification.
That changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Please plug the connector into the receiver firmly and in the correct direction. Do not damage
the cable, break, modify, pull or twist it. When pulling out the connector, it should always be
pulled by its housing not by the cable.
Keep fuel and exhaust away from plastic parts. This may cause damage or malfunction.
Attention during use
Any water ingress or moisture may cause damage or malfunction. Do not use in the rain or
expose equipment to water.
Always drive an RC car with care and do not use in:
Crowded places, near other people, especially small children.
Confined spaces. In the wet, in fog or at night time.
Never operate when tired, sick,taking medication, under influence of alcohol or any other
condition which may affect your ability to control the model.
Changes to the TX settings should only be made when the engine has stopped
(or motor wires disconnected).
Always turn on the TX first and then the power to the RX.
Reverse this procedure when turning off i.e. turn off the RX and then the TX.
Always check the fail safe function on Nitro cars prior to running the model.
Never loose sight of your model which could result in damage or injury.
After the smoke has cleared,
check if the item has cooled.
Stop the engine or motor of the model.
Turn the receiver switch off.
Turn the transmitter switch off.
Remove the battery and contact your supplier.
1