Acoms TECHNISPORT 2.4G II Bedienungsanleitung Seite 11

IMPORTANT
Electrical characteristics for 2.4GHz frequency
2.4GHz uses a very high frequency, the product will not be effected by motor noise.
However, the electrical signal characteristics are very different for lower frequencies.
The presence of metal parts or carbon between TX antenna and RX antenna, can weaken
the signal and cause interference. If RX antenna is covered by metal or carbon,
please change the position of the installation.
When racing, never switch on the TX in an area other than the drivers stand, to prevent
interference to other drivers.
2.4GHz signals are easily distorted by metal parts.
If the transmitter operation becomes slow at the track, please move
your driving position. Please also check that the receiver is correctly installed.
Any metal obstacle between driver and car may result in a loss of signal i.e. a metal crash
barrier on a racing circuit.
If you experience interference, stop the car, switch off the TX and then switch on again.
The transmitter will scan for a new band, which may improve the reception and reduce
interference.
More than 3.5V is necessary to operate the receiver correctly.
When running an electric car, if low voltage occurs the receiver may reset itself.
If you are using 4 or 5 cell power battery for driving, installing an additional power source for
the receiver is highly recommended.
10