DHC BT1000 HD Bedienungsanleitung Seite 15

10. Press «ENTER» when charging system test is
completed. Turn all accessory loads and
engine off. Press «ENTER» to read the system
test results.
11. Press "ENTER" to press result or not.
*24V System Test Printing: The printer will not
function for 24 Volt batteries system test printing.
The 24V system test result will be recorded till you
hook up to a 12V battery and the right screen
shows up. Please select "YES" and press enter key to print the result and then
disconnect the clamps. The screen will appear again after you reconnect the
clamps. Please select "NO" and press the enter key to go back to the main menu.
IN-VEHIVLE TEST
This is a combination test of both battery test & system test. Please refer to
above testing procedures or follow the instructions on the display of the tester.
TEST OVER. TURN
ALT. LOAD VOLTS
xx.xx V NORMAL
RIPPLE VOLTAGE
xx.xx V NORMAL
CRANKING VOLTAGE
xx.xx V NORMAL
ALT. IDLE VOLTS
xx.xx V NORMAL
PRINT RESULT?
PRINT 24V SYSTEM
RESULT?
15
15
OFF LOADS &
ENGINE
YES/NO
YES