Stand-Alone Mode - Eurolite Led Pix-144 Rgb Bar Bedienungsanleitung

Stand-alone mode

Automatic mode
In automatic mode, 16 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until Auto is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with ENTER again.
2 Now use the buttons UP and DOWN to adjust the running speed of the program from SP0 (slow) to SP9
(fast). Confirm with ENTER.
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until Soun is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
2 Now use the buttons UP and DOWN to adjust the microphone sensitivity to the volume of the music
(Se00 = low, Se99 = high).
3 If you enable the silent scene mode in menu item SInd, the LEDs will be switched off if the volume is too
low or if there is no sufficient bass beat. If you disable this mode the LEDs remain switched on during
periods without music.
Individual color mix
In the color mode Colo each of the LEDs can be individually adjusted for brightness. The device will
constantly emit the color adjusted.
1 Press the MENU so many times until Colo is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates RED for the color red and the corresponding brightness value. Use the buttons
UP and DOWN to adjust the desired brightness.
3 Confirm with the ENTER button. Now the color green can be adjusted, then blue.
Display reverse
To invert the display by 180°, press the MENU button so many times until dISP is indicated in the display.
Confirm with the ENTER button.
Indicate software version
To indicate the version number of the firmware (operating system of the unit), press the button MENU so
many times until Ver is indicated in the display. Confirm with the ENTER button. The version will be indicated
in the display.
Reset to default settings
The device can be reset to default settings. Press the MENU button so many times until rset is indicated in
the display. Confirm with the ENTER button.
26/36 00128833, Version 1.1