Studer AUTOLOCATOR Bedienungsanleitung Seite 23

STUDER AUTOLOCATOR
lnput:
2.8.1
Auto load
@rtrtr
The postroll is programmed analogously.
All parameters for the AUTO RECORD
mode are now defined.
Press
the
AUTO
REC key
to
instruct
the tape recorder to spool to the starting point. The yellow
AUTO REC LED
lights up. After the tape has been positioned at
the parking
point,
this LED
continues
to flash for approximately 5 seconds; it
then switches
off. During these five seconds PI:AY
+
REC
must be pressed for starting the
machine
in
AUTO RECORD mode.
The
tape recorder switches to
PI-AY,
the
REC LED flashes.
At the lN point the
machine
switches
to record, the REC LED is
continuously light. At the OUT point
the tape recorder switches back
to play until
the post
roll up to
the
reversal
time
is
reached. From there the tape is rewound to
the parking point.
lf
desired, this process can be restarted by pressing
PLAY
and
REC.
Procedure:
F265
@
m*t
rg
E
E
1.
Yes
Functlon:
Auto load is used
for
automatically programming
the drop-in and
drop-out
points by pressing REC or
PI-AY
respectively.
lf in the tape
recorder F265:
Auto load enable is set to YES, the AUTO
LOAD
function is
automatically assigned to the TRANS/REV
PI-AY key.
ln
the software branch 'tape deck, keys only' program F265 to yes.
Press
the play
key.
Press this
key,
the
LED
flashes.
At
the desired tape position activate REC in order to define the drop-in
address.
At
the desired tape position press PI-AYto define the
drop-out
address.
The drop-in/drop-out addresses are now stored.
EO|T|ON:
25. November 1991
E/9