Studer AUTOLOCATOR Bedienungsanleitung Seite 20

STUDER AUTOLOCATOR
2.6
LOCl...4 and VARISPEED command keys
Key:
Functlon:
When
this key is pressed, the tape recorder searches the tape position that
is
stored in the corresponding memory. The
tape position and the corresponding
memory number are shown on the LOCATE POSITION display.
lnput:
The SHIFT key assigns to
the LOC1.,.LOC4 keys the functions for controlling the
variable
tape speed (VARISPEED). The
red
LED
above
the
SHIFT
key indicates
the
SHIFT
state. On
the
LOCATE POSITION display
the tape speed of
the
machine
is
shown in ips (inches per second).
Each
of
these 4 LOC memories is loaded by pressing the TRANS/REV PIAY key
and
the corresponding LOC key. Possible values are those shown in the lower
display.
Note:
LOC
1
...4
are
the same memory
locations
that can also be
accessed
via the
numeric keypad.
This key activates the variable tape speed adjustment. When
the red
LED
above
the key is light, you can vary the tape speed by means
of
the UP >
>
DOWN <
<
keys. ln
this mode the
LOCATE POSITION
display shows the set deviation from
the nominal speed in semitones (HT)
or percent (PC),
depending on the display
format selected on the tape recorder. After
the
desired speed deviation
has
been set
you can terminate this function by pressing the
SET
VS key again, the
SET VS
LED
above
the key switches
off.
This key activates the variable tape speed operation. After this key has been
pressed
the red
LED
above
the key flashes, the tape recorder is now switched to
the speed
preselected
with the SET VS
function.
The
LOCATE
POSITION
display shows the current tape speed
of
the tape recorder in ips.
Note:
Also while the VARISPEED
function is active the
SHIFT
mode can be cancelled
by pressing the
SHIFT
key; the red LED above the SHIFT key switches off, the
yellow LED lights up. The red V SPEED LED continues to flash to
indicate the
VARISPEED mode. However,
the
LOCATE POSITION
display now shows again
the
last selected
LocATE PoslTloN.
The SINGLE LOOP key can be set
to
INSTANT LOOP by simple reprogramming
in
the menu
of
the tape recorder (F259: SINGLE LOOP MODE
A).
When
the
INSTANT LOOP
key
is
pressed, the loop
mode
is
activated
immediately. The loop is executed between the value in the lower display field
and
the value in effect
at
the time
the INSTANT LOOP key was pressed.
r
'lL'
in
the right-hand section
of
the display is light when the
INSTANT LOOP
function is active.
r
The smaller
of
the two values
is
always taken as the loop starting address.
r
The loop can be executed in
PLAY
or RECORD mode,
r
The loop is cancelled as soon as any new function is entered.
Example
r;Tl
E/6
EDfT|ON:
25.
November
.l991