Studer AUTOLOCATOR Bedienungsanleitung Seite 22

STUDER AUTOLOCATOR
2.8
AUTO RECORD mode
Key:
@
Functlon:
A
loop with
automatic drop-in/drop-out
can be
executed
with the
AUTO
RECORD
function. ln addition a PREROLL and POSTROLL can be programmed
so that the editing operation can be simulated electronically with
the
REHEARSE
function before it
is
subsequently executed.
IN POINT
OUT POINT
First
the lN and
OUT
points must be defined. The lN point is written into the
LOCATE POSITION memory
either
by
reading
out
a
LOCATE
POSITION
memory, by copying the current TAPE POSITION with
the
t
key,
or by
manually
entering it via
the keypad.
For having
the value defined as the lN point, the
keys
TRANS/REV
PI-AY
and lN must
be pressed consecutively. The same procedure
applies analogously to the OUT point.
After
this
entry
the
lN
and OUT point can be checked by pressing
the
tN or OUT
key.
The lN or OUT point
is
shown on the TAPE POSITION display for as tong as
the corresponding key is pressed. As soon as this key is released, the current
tape timer reading reappears on the TAPE POSITION display.
Examples
The
content of memory
-3 is
to be used
as
the lN point:
F-Aül
IREVPLAYI+[Ir']
E*"_l
lnrveLe,rl
*
lout
I
rnput:
FEcALL-]
trtrWf
The OUT point should be set to 2:30 min:
,nput:
trtrtrwr
Now
the
preroll and postroll must be entered. The preroll can be programmed
as
follows:
lf the
preroll is
less
than 10
seconds,
a
leading zero must be
entered, for
example:
E/8
EO|T|ON:
25. November 1991