D Iagnostics Menu - SystemAir TControl POD 3s Bedienungsanleitung

Issue date: 09.03.2018
D
iagnostics Menu
To access the diagnostics menu, select the header in the startscreen of the parameter menu, and press the ENTER key. Here you
will find various information, such as device type, software version, state of the inputs and outputs and controller state (current
manipulated variable).
A
pplication notice
SD-Card
Micro SD cards can be used to upload a new firmware or a new device configuration. With the PC configuration tool a configuration
file with extended parameter set can be created and uploaded via SD card. Only SD cards formatted in the FAT file system can
be used! NTFS and exFAT file systems are not supported.
Boot Loader
Because of an integrated bootloader a new application (update, upgrade) can be uploaded by means of a SD card. To
insert the SD card, the upper part must be removed. If the boot loader is activated, the ring illumination blinks in a 1s
cycle, while display is not triggered! After recognition of a SD card with a valid application the update process is started.
Now, ring illumination blinks in a 300ms cycle. After a successful update process (Duration approx. 2-3 minutes!) the
new application is started automatically. Afterwards, SD card shall be removed!
Software:
A detailed description of the parameter and the configuration software can be found using the following
The parameters for the display, set point and the controller can only be changed via the configuration
software.
D
imensions (mm)
Systemair GmbH Germany info@systemair.de oder http://www.systemair.de/
Page 9 / 27
link.