How To Change Transmitter Batteries - Carson REFLEX WHEEL Betriebsanleitung

Charging Jack
GB
Charging
Jack
Note: ON/OFF Switch should be at "OFF"
position before charging the batteries for the
transmitter. Only Nickel-Cadmium or Nickel-
Metalhydride batteries (Ni-Cd / NiMH), such as
CARSON 609000 or its equivalents, are to be
recharged. If you attempt to recharge other types
of batteries, they may burst and cause injury or
damage to you and others. DO NOT RECHARGE
OTHER TYPES OF BATTERIES, SUCH AS
ALKALINE!

How to change transmitter batteries

* To remove the battery cover, push the cover
locking and lift the cover. Insert AA batteries
respectively NiCd / NiMH rechrgeable batteries
and pay attention to the polarityIf the transmitter
voltage indicator LED fails to register, check the
8 REFLEX WHEEL CARSON Radio Control System 500016/500017
Polarity of charging jack
Push and
lift here
Steering Rate Adjuster
Steering Rate Adjster
Strokes of the Steering Servo Horn can be
adjusted by rotating this Steering Rate Adjuster, in
the range from 10% to 100%. The bigger the
percentage is, the more sensitively the Steering
Servo operates.
contacts, especially the negative(-) terminals and
recheck that batteries are fitted correctly. Also
make sure the batteries are fully charged.