Installation Method; Column; Base - Pioneer PDK-FS01E Bedienungsanleitung

7 Installation method

1 Remove the cable covers and insert the col-
umn into the base.

Column

Anchor the column with the bolt M8 (4 loca-
2
tions).
Column
3 Attach the glass stays (left, right) to the col-
umn.
1 Hold the glass stays slightly downward as you insert
them into the holes.
2 Push the end of each glass stay downwards and fix
it in place by inserting the pin in the notch.
1
Grass stay
4
Insert

Base

Base
Pin Notch
Pin
2
1
2
The side with the rubber
foot is the top side.
¶ The height can be adjusted in three stages: high,
medium, and low.
The standard installation location is the medium
position hole.
Glass stay (left)
Glass stay (right)
4 Attach the PDP attachment bracket to the
plasma display with the bolt M8. (4 locations)
¶ The height can be adjusted in three stages: high,
medium, and low.
The standard installation location is the medium
position hole.
Locations of the attachment
holes on the PDP attachment
bracket
High
Medium
Low
High
Medium
Low
Precaution
¶ Be sure to spread a sheet or similar protective material
to prevent scratches or damage to the display.
¶ Be sure to do this attachment with the plasma display
on a table or other flat surface.
¶ Be sure to use the middle and lower level screw
attachment positions on the plasma display. Do not
perform the attachment by combining the upper and
middle levels.
High
Medium
Low
PDP attachment bracket
Top side of
plasma display
High
Medium
Low
High
Medium
Low