Inhaltsverzeichnis
Werbung
Thank you for buying Pioneer's product.
Please read through the Operating Instructions to learn how
to operate your model safely and properly.
Please be advised to keep the Operating Instructions in
your place for future reference.
IMPORTANT NOTICE
Record the model number and serial number of this
equipment below.
Model No. PDK-WT02
Keep this number for future use.
WARNING
To prevent a fire hazard, do not place any naked
flame sources (such as a lighted candle) on the
equipment.
Installation
¶ Consult your dealer if you encounter any difficulties
with this installation.
¶ Pioneer is not liable for any damage resulting from
improper installation, improper use, modification, or
natural disasters.
Note to Construction Companies
Prior to installing this product, please read Pioneer's
technical manual thoroughly and heed its content.
Pioneer shall not be liable in any way for any accidents or
damage resulting from other than the specified assembly,
mounting and usage, from remodeling, or from natural
disasters or the like.
Contents
Cautions ................................................................... 8
Confirming the Parts Provided .............................. 9
Installation Procedure ............................................. 9
Adjusting the Angle .............................................. 12
Specifications ........................................................ 12
Dimension Diagram .............................................. 13
This symbol refers to a hazard or unsafe practice which
can result in personal injury or property damage.
8
En
Serial No.
D3-4-2-1-7a_A_En
CAUTION
Cautions
This product is a hung on wall unit for plasma displays
(PDP-506XDE / PDP-506FDE / PDP-506HDG / PDP-
436XDE / PDP-436FDE / PDP-436HDG) from Pioneer.
Use with other model is capable of resulting in instability
causing possible injury. For further information, please
contact the store where you purchased your display.
It should not be used for any other purpose, such as for
holding a plasma display, or remodeled in any way.
Improper installation is extremely dangerous because it
may result in it falling over or other accident.
Installation Location
• Select a vertical location that is strong enough to support
the weight of the wall mount and the plasma display.
Product weight is listed on page 12.
• Do not install it at a place where people can easily hang
from it or lean on it.
• Do not install it outdoors, at a hot spring, or near a beach.
• Do not install where vibration or shock may occur.
• There are cases where it cannot be installed because of
the structural strength of the wall, so consult with an
expert installer.
• Thoroughly read and always follow the plasma display
operating instructions for more information about the
installation location.
Assembling and Installation
• Assemble in accordance with the assembly
instructions and securely attach all screws at the
designated locations.
There have been cases where unforeseen accidents
such as the equipment breaking or falling over due to
incorrect installation have occurred.
• The display must always be installed by two or more
people to assure it is installed safely.
• Before installation, turn off the power for the display
and peripheral devices then remove the power cord
plug from the power outlet.
Make sure that the screws used to attach all parts never
become loose, because a loosened screw may result in it
falling over or other accident.
If you discover a fault or malfunction, immediately have an
expert installer perform repairs.
There is a danger of the hung on wall unit, parts attached to
the wall, or other places that cannot be seen being
damaged so that the plasma display falls over. Therefore,
when inspecting or repairing the display, or when
performing interior finishing work in your shop, be sure to
ask an expert installer to inspect these places. We
recommend that if possible, you ask an expert installer to
perform inspections at regular intervals.
If the hung on wall unit is used for a long time, the
environment may cause change over time, reducing its
strength. After five years, ask an expert installer to inspect
it to make sure that it can be used without any problems.
Werbung
Inhaltsverzeichnis
