Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Routine checks consist of the following:
1.
Check that the contents gauge
needle is in the green sector, showing
that the cylinder is fully-charged.
2.
Check that the bag is clean and
undamaged.
3.
Check that the anti-tamper tags are
in place and unbroken.
4.
Check that access to the bag is
unobstructed.
5.
Check that the quick fire strap and
pin are in place.
Apparatus that fails any of these checks
must be withdrawn from use and returned
for workshop service or repair.
4.3
AFTER-USE CLEANING
CAUTION:
DO
NOT
immerse
reducer/cylinder valve. Fluid must not
enter the inner mask.
1.
Wipe the surface of the hood and
bag
using
a
moistened in a solution of TriGene
(available from Scott Health and Safety
Limited under Article Numbers 2008247
for 1 litre, 2008248 for 5 litres) and warm
water.
2.
Allow the hood and bag to dry
naturally away from direct heat and
sunlight.
3.
Disinfect the neck seal using a
TriGene
hygienic wipe, available from
TM
Scott Health and Safety Limited under
Article Number 2004225 (Pack of 20).
4.
Use an Exxene
available under Article Number 2011081
(Pack of 10) from Scott Health and
Safety Limited, to polish the visor.
4.4
CHARGING CYLINDERS
WARNING:
•
HP compressors and charging
apparatus must only be used by
trained operators.
•
Wear
working with HP air.
•
Air used to charge cylinders
must conform to EN 12021 :
1999.
Remove Cylinder from Bag:
1.
Break anti-tamper tags, open the
bag flap carefully and release quick-fire
strap from firing pin.
2.
Open the bag fully and check that
firing pin is fully home. If necessary push
the actuator into the reducer/cylinder
valve and fit the firing pin.
3.
Ease the contents gauge through
the slot in the bag window and withdraw
the cylinder from the bag.
4.
Flex the hose and check for wear
and
damage.
service if hose is worn or damaged.
9
ELSA
the
hood
clean
lint-free
de-misting wipe,
TM
eye
protection
Return
apparatus
or
cloth
TM
when
for
Werbung
Kapitel
