BaByliss 7464E Bedienungsanleitung Seite 4

ENGLISH
HAIR CLIPPER
This BaByliss Clipper is of high quality
and includes attachments perfectly
designed to allow you to easily achieve
professional standard haircuts at home.
The stainless steel blades allow optimum
performance. The lightweight, powerful
motor needs no adjustment.
MAINS USE
Connect the transformer into the mains,
wait 1 minute and then switch into the
ON position.
IMPORTANT! Use only the transformer
provided with the 7464E clipper Voltage
= 4.5V - Tension = 1000mA
USING THE CUTTING GUIDES
Very practical, the cutting guide
guarantees equal cutting length.
IMPORTANT: Always attach the cutting
guide BEFORE turning the trimmer
on, and turn it off before changing the
guide.
CUTTING TECHNIQUES AND ADVICE
FROM THE EXPERTS
• Use the clipper on clean, dry hair.
• To familiarize yourself with the clipper,
begin with the cutting guide for a
longer cut, then, if you want a shorter
cut, adjust it by pushing the knob. You
will soon know the lengths of each
guide and each position.
• Always move the clipper against the
direction of hair growth.
• Begin at the nape. Place the guide on
the scalp and move the clipper toward
the crown of your head. Move your
clipper slowly, pointing the teeth of the
guide slightly upward. Keep the clipper
in contact with your head at all times.
• For the crown of the head, move
from front to back, that is, from your
forehead to the crown of your head.
• For the finishing touches, that is,
around the nape and sideburns, use
the clipper without a cutting guide.
Turn your clipper over and move it
from top to bottom.
• If you want a length greater than 30
mm, or if you are experienced, you can
create 'comb' or 'finger' cuts:
- Work without a cutting guide.
- Take up a small section of hair with a
comb or in your fingers.
- Move the comb or your fingers along
the section of hair to the desired
length.
- Cut your hair along the comb or your
fingers.
- Remove the cut hair using a comb
and check the evenness of the cut
regularly.
Using the thinning guide
Switch the clipper to the 'THIN' position.
The thinning guide is in front of the
blades.
This technique allows you to thin out
hair to make styling easier.
The technique is particularly good for
the crown of the head where hair is
usually thicker.
To thin you hair, take a section of hair
(rest your little and ring fingers on
your scalp, using the middle and index
fingers to set the length), hold 1 to 2 cm
below the cutting length. Then, using
the clipper, cut the
section of hair steeply and at an angle
to create a saw-toothed 'edge' .
MAINTENANCE
To maintain correct performance, the
blades must be regularly cleaned and
oiled. It is recommended to oil the blades
every time that the clipper is used, using
the oil provided. Never use any other
product: this oil was formulated for high
speed clippers, it does not evaporate or
slow down the blades.
4