Using The Remote Control For Other Equipments; Programming The Remote Control - THOMSON 15LB020S4 Bedienungsanleitung

Using the remote control for other equipments

The remote control supplied with your set can be used for
other equipment, such as video recorders or DVD players.
This page provides information concerning the remote
control's use with these types of equipment.
VCR
VCR
Press the VCR
button
DVD
On/Standby
MENU To display the main
menu
Vertical scrolling in
menus
Horizontal scrolling
in menus
To confirm an action
OK
EXIT To close a menu
0-9 To directly access
channels or enter
numeric values
PR+/PR- To change channels
AV To select AV input
REV Rewind
PLAY Play
FWD Fast forward
STOP Stop
PAUSE Pause picture
REC Record

Programming the remote control

Automatic code search
This method can be used to automatically find the most
DVD
appropriate code for your appliance.
1.
Switch on the appliance you wish to use the remote
control with.
2.
Press the relevant button for this appliance on the remote
control, and while holding this button down, press the
Press the DVD
standby button until the remote control light comes on.
button
Release the two buttons.
3.
On/Standby Point the remote control at the appliance and press
PLAY. Wait until the light stops flashing. If the appliance
To display the main
menu has not gone into standby mode after five seconds, press the
PLAY button again to continue the search for the next set of
Vertical scrolling in codes.Repeat this operation until the appliance goes into
standby mode. There are 20 sets of codes.
menus
4.
When the appliance goes into standby mode, press the
Horizontal scrolling
standby
in menus
Then press the REV button to put it back in standby mode,
and if necessary, keep pressing until the appliance goes into
To confirm an action
standby.
To close a menu
5.
Press the STOP button and hold it down until the remote
control light goes off.
To enter numeric
Note: you can cancel the programming operation at any
values or select
time by pressing the EXIT button.
options in menus
Manual programming
This method involves carrying out a manual search for the
codes to be used for controlling your other appliances.
1.
Switch on the appliance you wish to use the remote
Rewind
control with.
2.
Press the relevant button for this appliance on the remote
Play
control, and while holding this button down, enter one of
the codes relevant to your make of appliance (there is a list
Fast forward
of codes at the end of this manual). If the remote control
light flashes you have entered the wrong code or it is not
Stop
possible to program the remote control.
3.
Point the remote control at the appliance and press the
Pause picture
relevant button (VCR or DVD). Press the
If the appliance does not go into standby mode, try another
code.
Depending on the year of manufacture and the type of
appliance, some functions may not be available.
Certain codes may cover more functions than others. Test
the functions you can control and, if appropriate, try other
codes.
Note here the code(s) which work best.
When you change the remote control's batteries,
remember to reprogram it.
button on the right side to switch it on again.
Operation
En
standby button.
11