Makita DMR203 Betriebsanleitung Seite 7

INSTALLATION AND POWER
SUPPLY
CAUTION:
● Be careful not to pinch your fingers when
opening and closing the battery cover.
● Return the battery compartment locker to the
original position, after installing or removing
battery cartridge. If not, battery cartridge may
accidentally fall out of the speaker, causing injury
to you or someone around you.
● Always close and lock the battery compartment
locker before moving the speaker.
● Always switch off the speaker before installing or
removing the battery cartridge.
● Be careful not to drop or strike the speaker.
Broken shell may slash your finger or stab
your body. Damaged speaker may exhibit
unpredictable behavior resulting in fire, explosion
or risk of injury.
● Hold the speaker and the battery cartridge firmly
when installing or removing battery cartridge.
Failure to hold the speaker and the battery
cartridge firmly may cause them to slip off your
hands and result in damage to the speaker and
battery cartridge and a personal injury.
IMPORTANT:
● Reduced power, distortion, "stuttering sound" or "low
battery" appear on the display are all the signs that
the main battery pack needs to be replaced.
● The battery cartridge can't be charged via the
supplied AC power adaptor.
● The battery cartridge is not included as standard
accessories.
Installing or removing slide battery
cartridge (Fig. 3 and 4)
● To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the speaker, causing injury to
you or someone around you.
● Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, sliding it from the
speaker while pressing the button on the front of the
cartridge.
Indicating the remaining battery
capacity
* Only for battery cartridges with "B" at the end of
the model number
1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
● 14.4V/18V batteries
Indicator or lamps
Lighted
● 10.8V-12Vmax batteries
Indicator or lamps
Lighted
7 ENGLISH
1
Off Blinking
75% ~ 100%
malfunctioned
Off Blinking
75% ~ 100%
2
Remaining
Capacity
50% ~ 75%
25% ~ 50%
0% ~ 25%
Charge the
battery
The battery
may have
Remaining
Capacity
50% ~ 75%
25% ~ 50%
0% ~ 25%