Whirlpool w84be 72 x Gebrauchsanweisung Seite 45

Be careful not to damage the
floors (e.g. parquet) when moving
the appliance. Install the appliance
on a floor or support strong enough
to take its weight and in a place
suitable for its size and use. Make
sure the appliance is not near a
heat source and that the four feet
are stable and resting on the floor,
adjusting them as required, and
check that the appliance is perfectly
level using a spirit level. Wait at
least two hours before switching
the appliance on, to ensure that the
refrigerant circuit is fully efficient.
WARNING: When positioning the
appliance, ensure the supply cord is
not trapped or damaged.
WARNING: To avoid a hazard
due to instability, positioning or fixing
of the appliance must be done in
accordance with the manufacturer
instructions.
It's forbidden to place the
refrigerator in such way that the
metal hose of gas stove, metal gas
or water pipes, or electrical wires
are in contact with the refrigerator
back wall (condenser coil).
To guarantee adequate
ventilation, leave a space on both
sides and above the appliance.
The distance between the rear of
the appliance and the wall behind
the appliance should be 50 mm,
to avoid access to hot surfaces. A
reduction of this space will increase
the Energy consumption of product.
Please remove the power cord from
condenser hook during installation
before connecting product to power
supply.
ELECTRICAL WARNINGS
It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket in
accordance with the wiring rules
and the appliance must be earthed
in conformity with national electrical
safety standards.
Do not use extension leads,
multiple sockets or adapters.
The electrical components must
not be accessible to the user
after installation. Do not use the
appliance when you are wet or
barefoot.
Do not operate this appliance if it
has a damaged power cable or plug,
if it is not working properly, or if it
has been damaged or dropped.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its service
agent or similarly qualified persons
in order to avoid a hazard - risk of
electric shock.
WARNING: Do not locate
multiple portable socket-outlets or
portable power supplies at the rear
of the appliance.
CLEANING AND MAINTENANCE
WARNING: Ensure that the
appliance is switched off and
disconnected from the power supply
before performing any maintenance
operation; never use steam cleaning
equipment - risk of electric shock.
Do not use abrasive or harsh
cleaners such as window sprays,
scouring cleansers, flammable
fluids, cleaning waxes, concentrated
detergents, bleaches or cleansers
containing petroleum products
on plastic parts, interior and door
liners or gaskets. Do not use paper
towels, scouring pads, or other
harsh cleaning tools.
EN - 45