Replacing The Lamp; Troubleshooting - AEG BES33101ZM Benutzerinformation

after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.

12.6 Replacing the lamp

WARNING!
Risk of electric shock.
The lamp can be hot.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "12.00".
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
A
The back lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
There was a power cut.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Reset the clock.
ENGLISH 25