Replacing The Lamp; Troubleshooting - AEG BPB331021B Benutzerinformation

24 www.aeg.com
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The middle panel (B) has a
decorative frame. The screen-printing
zone must face the inner side of the
door. Make sure that after the installation
the surface of the glass panel frame (B)
on the screen-printing zones is not rough
when you touch it.
A B
Make sure that you install the middle
panel of glass in the seats correctly.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
You cannot activate or oper-
ate the oven.
The oven does not heat up.
The oven does not heat up.
C
Possible cause
The oven is not connected
to an electrical supply or it is
connected incorrectly.
The oven is deactivated.
The clock is not set.

10.7 Replacing the lamp

Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
A
4. Install the glass cover.
B
C
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Activate the oven.
Set the clock.