Aerfast TS55-AC Betriebsanleitung Seite 7

Operational Precautions
General Safety Instructions
1. Consider work area environment. Do not expose tools to rain. Do not
use tools in damp or wet locations ： Keep work area clean and well lit. Do
not use tools in the present of flammable liquids or gases.
2. Guard against electric shock. Avoid body contact with earthed or
grounded surfaces.
3. Keep children away. Do not let visitors touch the tools or extension cord.
All visitors should be kept away from work area.
4. Store idle tools. When not in use, tool should be stored in a dry locked
up place, out of reach of children.
5. Do not force the tool. It will do the job better and safer at the rate for
which it was intended.
6. Stay alert. Watch out what you are doing：Use common sense. Do not
operate tool when you are tired. Check damaged parts. Before further
use of the tool, a guard or other part is damaged should be carefully
checked to determine that it will operate properly and perform its
intended function.
7. Check for alignment of moving parts, blinding of moving parts, breakage
of parts, mounting and any other condition that may affect its operation.
8. A guard or other parts that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated in
this instruction manual. Have defective switches replaced by an
authorized service center. Do not use tool if switch does not turn it on.
9. To ensure the designed operational integrity of power tools, do not
remove installed cover or screws.
10. Use your tool at lower input than specified on the nameplate, otherwise,
the finish may be spoiled and working efficiency reduced by motor
overload.
11. Do not wipe plastic parts with solvent. Solvents such as gasoline,
thinner, benzene, carbon tetrachloride, alcohol, ammonia and oil
containing chloric annex may damage and crack plastic parts. Do not
wipe them with such solvent. Wipe plastic parts with a soft cloth lightly
dampened with soap water.
12. Dress properly. Do not wear loose clothing or jewelry. Contain long hair
keep your hair, clothing, and gloves away from moving parts.
13. Use safety equipment. Always wear eye protection, non-skid safety
shoes, hard hat, or hearing protection.
14. Do not overreach. Proper footing and balance enables better control of
the tool in unexpected situations.
△, ! WARNING