Aerfast TS55-AC Betriebsanleitung Seite 15

Replaceable Carbon Brush
1. Replace the new carbon brush, while the motor is not rotated and the
carbon brush is run out.(Change the new motor after the carbon brush has
been replaced 2~3 times)
2. Replacement procedure is as follows:
Loose the carbon brush panel counterclockwise by using slotted
bit.(Fig.1).
Take out the carbon brush ( Fig.2 ).
Put the new carbon brush and carbon brush panel back into the housing
in proper order. (Fig.3)
Lock the carbon brush panel back clockwise by using slotted bit. (Fig. 4)
Caution
Always be sure that the machine is switched off and is unplugged from the
power outlet removed before carrying out any work on the machine.
To maintain product safety and reliability, repairs, maintenance or adjustment
should be carried out by an authorized service center.
Fig.1
Fig.3
Fig.2
Fig.4