Suntec Wellness KLIMATRONIC Heat Flow 2000 Design Bedienungsanleitung Seite 16

 Please do not use an extension cord, since it could come
to a fire hazard and overheating.
 In order to prevent an overload, please do not use power
strip, where other devices are connected to it.
 Do not allow any water in the unit. If the unit gets wet, the
use should be discontinued immediately.
 The plug must be securely mounted in the socket, since it
could lead to overheating. Contact your dealer if repair is
required please.
 The
device
automatically shuts down the heater in case of overheating.
Once the unit has cooled, it automatically switches on
again.
 The convector must not be placed directly under a wall
socket.
Warning: In order to avoid overheating, do not cover
the heater.
Please do not use timer or any other device to start the
convector automatically. There is a fire hazard if the appliance
is covered or positioned incorrectly.
Installation
Assembly for floor
Attach to the base of the heater using the 4 tapping screws provided, taking care to ensure that they are located correctly
in the bottom ends of the heater. See fig.1
Base
Fig.1
has an
Screws
overheating protection which
Base