Bestway 58497 Gebrauchsanleitung Seite 12

Filter:
This function is used to filter pool
water and should be positioned here 99% of the
time. Water is pumped through the sand filter,
where it is cleaned and returned to the pool.
A
Backwash:
the sand bed; water is pumped down through
the Collector Hub, upwards through the sand
bed, and deposited out of Port D.
A
Drain:
This function drains water from the
pool; another filter bypass setting, water is
pumped and deposited out of Port D, instead of
returning it to the pool.
A
NOTE:
• Be sure all provisions for wastewater disposal meet applicable
local, state or national codes. Do not discharge water where it
will cause flooding or damage.
• When the Control Valve is set to the Backwash, Rinse, or
Drain position, water will discharge from Port D on the Control
Valve.
C
B
This function is used to clean
C
D
B
C
D
B
Closed:
This function stops water
flowing between the sand filter and the pool.
A
Rinse:
This function for initial startup, cleaning,
and sand bed leveling after Backwash; water is
pumped downwards through the sand bed, up
through the Collector Hub and deposited out of the
valve Port D.
A
Circulate:
This function circulates pool
water bypassing the sand filter; use this function
if the filter is broken to collect debris in the
Debris Screens.
A
12
C
B
C
D
B
C
B