Inhaltsverzeichnis
Werbung
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may
be replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs
(e.g. Ecoboy: Sava Plug) or to power
inverters which convert the direct
current to 230 V alternating current
(e.g. solar equipment, power supplies
on ships).
Switching on the
appliance
Fig. 2
Press main switch on appliance 1.
Interior light illuminates, lamp flashes.
At the factory the refrigerator
compartment was set to +5 ºC.
We recommend a setting of +4 °C.
Perishable food should not be stored
warmer than +4 °C.
Selecting the
temperature
The set values can be changed; see
description of the fascia.
Operating information
The temperature in the refrigerator
compartment becomes temporarily
colder:
S If large amounts of fresh food are frozen
in the freezer compartment.
The temperature in the refrigerator
compartment becomes warmer:
S If the appliance door is opened
frequently
S If large amounts of food are inserted.
en
21
Werbung
Inhaltsverzeichnis
