Connecting The Appliance; Switching On The Appliance; Operating Tips - Balay KGS Series Gebrauchsanleitung

en
Connecting the
appliance
After installing the appliance, wait at least
½ hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior. See Cleaning
the appliance.
The socket should be freely accessible.
Connect the appliance only to 220 240
V/50 Hz AC current via a socket which
has been properly installed. The socket
must be fused with a 10 A fuse or higher.
If the appliance is to be operated in
a non European country, check on the
rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to
electronic energy saver plugs or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
24
Switching on the
appliance
Fig. 2
The appliance is switched on and off with
button 1.
The factory has recommended and set
the following temperatures:
Refrigerator compartment
Freezer compartment

Operating tips

S While the refrigerating unit is running,
beads of water or hoarfrost form at the
back of the refrigerator compartment.
This is quite normal. The condensation
flows into the evaporation area of the
appliance via the condensation
channels and the drainage hole.
S The sides of the housing are sometimes
heated slightly.
This prevents condensation in the area
of the door seal.
S If the air humidity is high, condensation
may form in the refrigerator compart
ment, especially on the glass shelves.
If this is the case, pack or wrap the food
and select a lower temperature in the
refrigerator compartment.
S If you cannot open the freezer
compartment door immediately after
closing it, wait 2 3 minutes until the
partial vacuum has equalised.
+4 °C
-18 °C