Start Up Infinity Ap Only - BWT Infinity A Einbau- Und Bedienungsanleitung

EN
Input 24 V
28
Set
CIC Output
10.2

Start up Infinity AP only

The required backwash interval must be set on
the filter.
Press Set to set the interval.
Key
Press Set for 5 seconds
Display dots flash; device is in programming
mode
Press Set
Press Set
Press Set
Press Set
Pressing the Set key again steps up the number of
h (hours) or d (days).
The hours h run from 1 – 24, followed by days d from
2 – 56, followed by the hours again etc.
Press the Set key until the desired value has been
set. The value is saved 10 seconds after the last
input. The display dots fade out. The unit back-
washes.
The time until the next backwashing and the pres-
sure difference appear alternately in the display.
The pressure difference is only displayed for large
volumes of water.
The filter is ready for use.
Display
SL 0
SL 1
SL 2
SL 3
1 h