Maintenance advises
Never use hydrochloric acid. Only use a pH corrector product which is recommended
by your professional.
The use of any other chemical product can lead to irreversible damage to the device.
CORRECTIVE MODE SETTING
There are 2 kinds of correctives : ACID – BASE
The device is pre-programmed with an ACID corrective mode. To change this value, you need to
enter the instruction pH menu:
1.
Press 3 sec simultaneously on the
(C) and (D) keys. The LED of
corrective mode related flash
If manipulation is done out of pH
menu, the device will put on hold.
2
Set the corrective mode wished with
the (C) and (D) keys and you are
done.
5
USE
CHECK THE WATER PARAMETERS
When installing the device and for every new season using the device. It is necessary and impor-
tant to check if the following parameters are correct:
State of the water
48
Clear, free from seaweeds and sediments.
Stabilized between 7.0 and 7.4
Important: The efficiency of the chlorine decreases very quickly with the
pH
increase of the pH and the scale deposits appear all the more fast as the pH
rate is high or unstable.
The water must be correctly balanced (TAC, TH) :
•
TAC / TH
•
A
LOW
B
The TAC (Permanent Hardness) indicates the bicarbonates rate dissol-
ved in water.
The TH, indicates the hardness of water, and at the same time the con-
tent in salts like calcium or magnesium dissolved in the water.
MV-1815-12-2017 . © All rights reserved Swim & Fun Scandinavia ApS
CAL
7.0 7.2 7.4 7.6
C
UK
E
HIGH
D