Parameters Adjustment - Swim & Fun Easy pH Bedienungsanleitung

UK
Note
Do not put the corrective bin directly under the device. An incorrect positioning of the
injection connector can entail the deterioration of the pump.
4

PARAMETERS ADJUSTMENT

CONTROL PANEL FOR MINIPH LED MODEL
A) Low pH Safwty LED
B) PH display LED's
C) Key for the pH probe calibration
D) Key for the pH instruction calibration
E) High pH Safety LED
PH INSTRUCTION SETTING
4 set points are available: 7.0 - 7.2 - 7.4 - 7.6
The device is pre-programmed with a 7.2 set point. To change this value :
1. Press 3 sec on the key SET (D). The recorded setpoint LED flashes.
2. Adjust the desired setpoint using the keys (C) and (D)
3. To valid, press 3 sec on the key SET (D). The setpoint LED freezes. Then, the device
goes to the choice of pH corrective mode.
Press on the CAL key (C) for 3 seconds to return to pH display.
MV-1815-12-2017 . © All rights reserved Swim & Fun Scandinavia ApS
A
CAL
LOW
7.0 7.2 7.4 7.6
B
HIGH
C
D
E
47