Eldom Jewel miami Perfect Juicer PJ500 Gebrauchsanweisung Seite 8

pic.
2
USING THE APPLIANCE
– place the assembled device on a stable and at surface,
- connect the device to the mains,
- make sure that the juice container (14) is placed under the opening and the valve (8) is open,
- make sure that the pulp container (13) is placed under the opening (7),
- turn the device on by pressing the top part of the switch (10) ( g. 5),
- insert the prepared products in series into the dispensing channel located in the lid (2)
and use the pusher (1) to press the products down into the rotating auger (3),
- when you are done, turn the device o by placing the switch (10) in the OFF position ( g. 5).
Never insert your ngers or any objects into the dispensing channel.
- the juice will pour directly into the juice container (14), and the pulp will be kept in the pulp container (13),
- the valve in the juice outlet can be closed for a short time so as to replace the juice container, and to prevent the
remaining juice from dripping,
- if the auger is locked, press and hold the bottom part of the switch (10) in REVERSE position for 3-5 seconds.
Repeat the process 2 or 3 times, then disable and dismantle PERFECT JUICER (see the CLEANING section) so as to
remove the locking piece.
After processing all products and when the juice stops pouring out, turn the device o and wait until it stops.
Do not exceed the maximum time of continuous operation of the device. Any failure to comply with the above, as
well as any failure to keep the device idle for the required time may irreparably damage the engine.
A- lter with small meshes,
watery juice
B- lter with big meshes,
dense juice
pic.
3
A
pic.
4
B
8
pic.
5
ON
OFF
REVERSE