Connect The Router - Linksys WTR54GS Handbuch

There are two ways to configure the Router. Choose one of the following:
• Run the Setup CD-ROM - It is strongly recommended that you use the
Setup CD-ROM. Insert the Setup CD-ROM into the CD-ROM drive, and
follow the on-screen instructions.
• Use this Quick Installation guide - If you wish, you can use the Router's
Web-based Utility. Proceed to Step 1 of this Quick Installation.
1

Connect the Router

A
Power down your network
devices.
B
Locate an optimum location for
the Router. The best place for the
Router is usually at the center of
your wireless network, with line of
sight to all of your mobile stations.
C
Connect a standard Ethernet
network cable to the Router's
Internet port. Then connect the
other end of the network cable to
your broadband modem.
D
Connect your computer or
Ethernet device to the Router's
ethernet port using standard
Ethernet network cabling.
E
Power on the broadband
modem.
F
Connect the AC power cable to
the Router's Power port and the
other end into an electrical outlet.
G
Power on the PC you wish to use
to configure the Router.
Proceed to Step 2.
2
C
D